Most common eras

2017 Standard rollover jig with wheel kit For Sale

Roll over jigs are great for body restoration and race preparation making welding in floors, sills and enclosed sections a lot less daunting especially for those newer to restoration been able to have the car body at a angle that not only is easier to work on but also allows you actually see what your doing there is also the safely aspect of not having to weld or angle grind underneath with all the hot sparks falling on you and burning your skin. The Roll and Restore jig can roll full 360 degrees with a 12 point degree locking ring. The rotation point is fixed but the inner frame has around 400mm of adjustment to balance the body making it easier to rotate. By using a clamping system it can be set to any point within of the 400mm adjustment. Built from heavy duty 60x60mm steel box section and fully welded frames. easy assembly simply slide the inner frame in add a cap and bolt each side and the jigs ready. This version comes with the 5 heavy duty 125mm(rated to 270kg per wheel) nylon castor kit making it very mobile for moving rather around the workshop or in and out of the garage to be worked on. comes in perfect for blasting stops all the workshop mess and dust. Can be very useful in smaller garages as it can give you that bit more working space you need. Each corner castor has a brake for safety. The connecting bar goes up to a length of 4600mm(4.6 meters). The jig comes complete with a 12 hole locking degree ring and 20mm spring bolt so easy to find the right position. Comes complete with standard set of 450mm long mounting irons(brackets) that will fit most cars. Simply drill holes in the mounts to match existing holes in the body or you can make new holes in both if easier. Once brackets are mounted make sure the cross bar is centred and then drill the holes though to mount the brackets to the jig. Custom brackets can be made if needed please message me for more info. All mounting hardware is M10 or M12 8.8 or above. When not in use the jig fits easily fits in to the space of a pallet also comes in handy when painting to hang parts off. These jigs have been used on nissan 200sx's to ford mustangs to MGBs If your worried about headroom in your garage the pivot point is 1305mm. So you can roughly work it out by adding 1305mm(130.5cm) to half the width of your car if this is less than the height of your garage or workspace you should be fine tho i do recommend 100mm. If not let me know as the jig can be built lower to suit your garage height. I try to keep the jigs in stock but do sell out now and again. I normally can get one delivered to within 10 working days if I don't have one. please see my other listing for the other versions of this jig. Delivery will be via pallet mainland is £39 with parts of Devon, Cornwall, Scotland been slightly higher so for the best quote please message me your postcode. Collection welcome. See last pic fits in a normal hatch back even with the wheel kit and connecting bars. It will even go in a K11 mirca with the seat down!!!!! Please message me or give me a call/text 07539009985 if you need any advice or have any questions.
This advert has now been removed through sale or otherwise, please see the list below for similar live adverts